Bosch Serie 6 Service Mode

Mastering the Hidden Menu: A Complete Guide to Bosch Serie 6 Service Mode

Resetting the Machine:

Sometimes, you need to perform a full reset.

Preparation

: Close the door and ensure the program selector dial is in the Off position . bosch serie 6 service mode

1. Enter service mode.
2. Select drain pump test: observe pump activation.
3. If pump runs but no water drains: check hose for kink/obstruction or external plumbing.
4. If pump does not run: open service panel, inspect pump wiring and capacitor, measure pump coil with multimeter, apply mains briefly to verify motor (safely, with power disconnected and proper procedure).
5. Check error memory for F18 and inspect PCB relays/triacs driving pump.

1. Enter Service Mode as described in Part 2.
2. Navigate to Test Code 99 (varies by software version, sometimes 88 or 00).
3. Press and hold "Start/Reload" for 10 seconds.
4. The display will flash "End" or "FAb" (Factory adjustment block).
5. Immediately after reset, you must run a calibration:

'Speed 60'

Press and hold the and 'Rinse' buttons (or the two buttons labeled 'Reset' on some models). While holding them, press the On/Off button. Release all buttons when P0 appears on the display. Viewing Errors Mastering the Hidden Menu: A Complete Guide to