Jungheinrich Etv 216 Error Codes __top__ -
Jungheinrich reach truck error codes (event messages) typically use a four-digit format that identifies the specific function group and the nature of the fault
- Turn off the key, wait 2 minutes for capacitors to drain, then restart.
- Inspect the 9-pin Deutsch connectors under the floor plate.
- Measure termination resistance between CAN High and CAN Low (should be 60 ohms).
CanDis (CANbus Display)
Most ETV 216 models are equipped with a . Under normal conditions, it shows battery status, operating hours, lift height, and weight. When an error occurs, the display switches to a hexadecimal or decimal code format. jungheinrich etv 216 error codes
has timed out. This often requires checking the control part or replacing the component. Turn off the key, wait 2 minutes for
- Meaning: A sensor fault has been detected (e.g., temperature, pressure, or position sensor).
- Solution: Check the sensor connections and cables. Replace the faulty sensor if necessary.
or motor connection wires; could be a wire breakage or a faulty motor. sd95d2cbd361a0b8d.jimcontent.com General System Messages Low Voltage CanDis (CANbus Display) Most ETV 216 models are
1908.1
: Seat belt or belt lock not closed while pressing the drive pedal.